USB DSO3204A Windows 10 Drivers

amy · Post time 2016-8-19 08:53:55

Dir sir,
Please enter into this link: http://eediscuss.com/forum.php?mod=viewthread&tid=6991&extra=
Click DSO3204A_Driver.zip to download.

amy · Post time 2016-8-19 17:11:17

Please refer to the document to install the driver.

amy · Post time 2016-8-20 17:19:03

Dir sir,
Please tell me the S/N of your device. And when did you buy it?

amy · Post time 2016-8-22 11:15:58

Sir,
The device can work on Win7 normally?
When you do self calibration, do you input any signal to 4 channels? Please don't input any signal to try.
About the voltage measurement, please give us a short video to study.

amy · Post time 2016-8-23 15:27:33

OK, we are waiting for your video.

amy · Post time 2016-8-26 15:23:01

Edited by amy at 2016-8-26 15:24

Dir sir,
I want to send a software to you. Please give me your email.
Please install the latest software to try.
If not, please change a Win7 computer to try.
By the way, please unplug the probe to do self calibration.

amy · Post time 2016-8-30 09:15:42

Dir sir,
For calibration, disconnect any probes or cables from the input connectors.
About the latest software, you can send a mail to support@hantek.com to get.
Please test it on win7, convenient for us to find the reason. Thank you for your cooperation.

amy · Post time 2016-8-31 08:57:48

Please keep us informed of the situation of this problem.

amy · Post time 2016-9-1 10:03:06

Sir, we had send the software to your email yesterday. Just sent again. Please check.

amy · Post time 2016-9-5 10:24:34

Dir sir, we had send the software to your new email in September 2, and you told me you had received.
Please use the new software to test. If the problem exusts, please give us a short video to study.
For accurate calibration, power on the oscilloscope and wait twenty minutes to ensure it is warmed up.

USB DSO3204A Windows 10 Drivers

This post contains more resources

This post contains more resources