|
Thank you for the calibration manual. It is very helpful. Stepping through the process works very well until I get to the following:
○ Press ENTER and CAL_DOWN keys at the same time to make the monitor display "SCAL" - millivolt output full-scale calibration.
○ If the value displayed on the monitor does not match the reading of the standard meter (-10.000mV), press the direction down key (the reading of the standard table will become smaller) and press the direction up arrow key (the reading of the standard table will become larger). Adjust until the two are equal.
The source reading on the Hantek is -10.000mV SCAL and my monitor -10.136. When I press the up arrow the reading doesn’t change, but pressing the down arrow causes it to go in the wrong direction. It changes from -10.136, -10.157, -10,162…. Do you have any suggestions?
|
|