Title: IDSO 1070A signal distortion [Print this page] Author: Jeffrey Time: 2019-3-12 15:49 Title: IDSO 1070A signal distortion Dear Hantek service,
I got a good tool(Oscilloscope) for cabling to wireless at begin.
But I have problem to test on my devices (Not each device has the symptom)
When I span signal the wave seems good, but if view overall signal then wave seems distortion.
Here is what I experiment as below
I checked two devices have similar period (1/4.8MHz).
According to Nyquist theorem if the signal without distortion the lowest sample rate must double real signal frequency.
Is it the software display problem?
Can I do anything improve it?
BTY, do we have higher sampling rate wireless oscilloscope?(One of my suspect is low sample rate)